AMPLIFIERSRM100MODULAR TUBE HEADOWNERS MANUAL
MTS Power Tube Bias System What is bias? Simply put, it is a circuit inside the power amplifier section that controls the “idle current” that flows th
You should always check the bias readings whenever you replace output tubes and re-adjust if needed. Since we’ve made it so simple,there is no reason
Dear Randall Owner,Congratulations on the purchase of your new Randall Amplifier, and thank you for the support of our product line. Randall amps ar
Replacing modules: When exchanging modules, simply turnboth thumbscrews to the left until they fill loose.(Do notremove the screw completely). Remov
Front panel Features and controls:The RM100 front panel consists of 1/4” input, channel switch, effects level, Master level, Density & Presence co
1 234561. Input jack: 1/4” input for your guitar. Connect you guitar to this input jack.2. Channel switch: Push and release button to switch between
Rear panel special features and controls:MIDI in/thru:Connect the included 7-pin MIDI footswitch and cable to the MIDI in. The thru can be run to any
1- AC Power/Voltage Selector: This amplfier can operate at AC currents of 100V, 110V, 120V, 230V. Simply remove the fuse with asmall screwdriver, a
MTS SeriesEFFECTS LOOP OperationsThe MTS effects interface is the most versatile loop system you will find anywhere. There are two totally ndepenent
Parallel Loop- cont.This can even be derimental to your tone, because the dry output signal of many effects units is out of phase with the input.Conse
Commentaires sur ces manuels